SLIP Interface

The Serial Line IP (SLIP) protocol is a very simple way to transmit IP packets over a serial line. It does not provide any framing or error control and is therefore not widely used today.

You can enable or disable the SLIP interface. You can also configure the Local IP Address, Net Mask, Primary DNS, and Secondary DNS Server IP address.

Network settings in this topic are valid for the SLIP Interface only. They must be set separately for each network interface. You must carefully configure those parameters to match the settings of your remote peer. SLIP protocol does not support any of the automatic configuration protocols.

The network settings are used to route packets from the stack to the proper network interface on transmit.

SLIP Network Interface switch enables or disables the SLIP Network interface. When the SLIP Interface is not used, it should be disabled to reduce the application code size. It is enabled when this value is set to 1.
```
#define SLIP_ENABLE    1
```

IP Address specifies your local static four byte IP address.

#define _IP1S          192
#define _IP2S          168
#define _IP3S          225
#define _IP4S          1

Subnet Mask specifies the Net Mask. This is normally class C for small LANs: 255.255.255.0. It is used by the system to route packets to network interfaces.
```
#define _MSK1S         255
#define _MSK2S         255
#define _MSK3S         255
#define _MSK4S         0
```
Primary DNS Server specifies the IP address of the primary DNS Server. The DNS Client sends IP address resolution requests to this address. This setting is irrelevant when the DNS Client is disabled by configuration.
```
#define _pDNS1S        194
#define _pDNS2S        25
#define _pDNS3S        2
#define _pDNS4S        129
```
Secondary DNS Server specifies the IP address of the secondary DNS Server. This DNS Server is used when the primary DNS Server is down or not accessible. In this case, the DNS Client automatically switches to a backup secondary DNS Server if a non-zero address is provided.
```
#define _sDNS1S        194
#define _sDNS2S        25
#define _sDNS3S        2
#define _sDNS4S        130
```
Use Default Gateway on remote Network option applies when both Ethernet and SLIP dial-up networks are used simultaneously. If enabled, data that cannot be sent to a local LAN is forwarded to the Dial-up SLIP network instead.
```
#define SLIP_DEFGW     1
```

Note

If both SLIP and Ethernet Interfaces are used simultaneously, you must not set the same network group address for both the Ethernet and SLIP interfaces.