Signum Systems

Emulators

ADM-51 is a small, palm-sized emulator based on a 2-pin, synchronous debug channel. It is equipped with USB 2.0 port that runs at 480 Mb/sec and is fully compatible with the older USB 1.1 ports at slower speeds. ADM-51 is very portable and requires no external power adapters. All power is taken from the USB port which allows it to be used in the field when connected to a notebook PC.

JTAGjet-166

JTAGjet-166 is a small, palm-sized, JTAG emulator for Infineon XC16x and TriCore devices. It comes with USB 2.0 high-speed interface that runs at 480 Mbps, which translates into super-fast program downloads. JTAGjet-166 features:

Super-fast program downloads.
Autodetection of all devices on the JTAG chain.
Automatic processor initialization on power-up and Reset
Also supports all TriCore, ARM7, ARM9, OMAP and TMS320 DSPs.
Compatible with C166 Keil compiler.
Adaptive or programmable JTAG clock speed (0-30 MHz).
Integrated Smart Flash Programmer for internal XC16x Flash as well as external Flash from AMD, Intel and others.
Remote debugging over TCP/IP networks.
Auto-sensing JTAG probes (0.9V to 5V).

USP-51

The USP-51 offers 100% real-time, non-intrusive emulation (up to 60MHz) with no restrictions on userâ€™s software or hardware. It supports serial or parallel interface to the PC. Comes with Chameleon Debugger for Windows 98, ME, NT4, 2000 and XP. Features

HLL debug for C-51 and ASM-51
Up to 256K of overlay Program RAM with bank switching
Up to 64K of overlay External Data RAM
Memory display and edit while executing in real-time
In-line symbolic assembler and disassembler
Memory mapping on 256 byte boundaries
Up to 256K of real-time hardware breakpoints
32K frames (80 bits wide) of execution Trace Buffer with time stamp
Trace display during execution
Pass-points to monitor internal RAM, variables and Registers while running
Breakpoints on Register and internal RAM values
Complex Events to trigger Breakpoints or Trace logic
Two 16 bit Pass Counters
8 level hardware event Sequencer
8 channel user logic state analyzer
External trigger input and outputs
Performance analysis and histograms
Coverage Analysis to report unexecuted code with reports
Remote debugging over TCP/IP network

Check with Signum to determine the exact emulator configuration for your application.