Keil Logo Arm Logo

ULINKpro 5Volt Adapter

The 5Volt (5V) Adapter enables ULINKpro to connect to 5V-only target devices.

ULINKpro 5V Adapter
ULINKpro 5V Adapter.


  • Expands the I/O Voltage range to 1.5V - 5.5V to accommodate 5V-only devices
  • Supports JTAG and SW clock speeds up to 50MHz
  • Provides full speed data trace capture (SWV)
  • Supports instruction trace capture up to 400 Mbps using 4-pin ETM
  • Target Connectors
    • 10-pin Cortex debug (0.05 inch connector)
    • 20-pin Cortex debug + ETM Trace (0.05 inch connector)

The 5V Adapter replaces ULINKpro's standard 20-pin ribbon cable, and connects to either the 10-pin (Cortex Debug) or 20-pin (Cortex Debug + ETM) connectors on Keil evaluation boards.

Notes Note

  • The 5V Adapter is not included as standard with ULINKpro. It must be purchased separately.
  • The 5V Adapter is only required when working with 5V only devices.
Keil logo ARM logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings