Keil Logo Arm Logo

ULINKpro Isolation Adapter

The Isolation Adapter is an optional accessory which provides electrical isolation between the target system and the ULINKpro debug and trace unit. Electrical isolation is essential when working with systems that may generate high-voltage spikes such as motor control, or where there is no common ground plane.

ULINKpro Isolation Adapter
ULINKpro Isolation Adapter.

The Isolation Adapter uses digital isolation technology which enables it to support high-speed debug and trace as well as a wide target voltage range.

Features

  • Provides digital isolation up to 1,000V (1KV)
  • High-speed Debug - JTAG (15MHz) and SW (20MHz)
  • Full-speed data trace capture (SWV)
  • Supports instruction trace capture up to 150 Mbps using 2 or 4-pin ETM
  • Enables timing synchronization with optional power measurement probes
  • Wide I/O Voltage range 1.8V - 5.5V
  • External power (via USB connector) minimizes power taken from target
  • Target Connectors
    • 10-pin Cortex debug (0.05 inch connector)
    • 20-pin Cortex debug + ETM Trace (0.05 inch connector)

The Isolation Adapter replaces ULINKpro's standard 20-pin ribbon cable, and connects to either the 10-pin (Cortex Debug) or 20-pin (Cortex Debug + ETM) connectors on Keil evaluation boards.

Notes Note

  • The Isolation Adapter is not included as standard with ULINKpro. It must be purchased separately.
  • The Isolation Adapter is not suitable to use with ULINK-ME, ULINK2, or the original ULINK adapter.

Keil logo

Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings