Technical Support

Support Resources

Product Information

MCBSTR9: ETM Connector Problem

Information in this article applies to:

MCBSTR9 Evaluation Boards

QUESTION

The ETM connector on MCBSTR9 does not work on board revisions before Vers 3 since it appears that the ETM pins are mirrored.

ANSWER

This is a known issue for older MCBSTR9 Boards. MCBSTR9 Vers. 4 has a correct layout for the ETM connector.

SEE ALSO

Last Reviewed: Thursday, January 21, 2021

Did this article provide the answer you needed?

Yes No Not Sure

Cookie Settings | Terms of Use | Privacy | Accessibility | Trademarks | Contact Us | Feedback

Copyright © 2005-2019 Arm Limited (or its affiliates). All rights reserved.

Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.