Technical Support

Support Resources

Product Information

MCB2300: ETM Connector Problem

Information in this article applies to:

MCB2300 Evaluation Boards

QUESTION

The ETM connector on MCB2300 does not work on board revisions Ver 3.0 or before since it appears that the ETM pins are mirrored.

ANSWER

This is a known issue older MCB2300 Boards. MCB2300 Vers. 3.1 has a correct layout for the ETM connector.

SEE ALSO

Last Reviewed: Tuesday, February 23, 2021

Did this article provide the answer you needed?

Yes No Not Sure

Cookie Settings | Terms of Use | Privacy | Accessibility | Trademarks | Contact Us | Feedback

Copyright © 2005-2019 Arm Limited (or its affiliates). All rights reserved.

Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.