Phytec 11. phyCORE-ST10F168 System on Module (SOM)

The phyCORE-ST10F168 supports high-end 16-bit controllers from STMicroelectronics featuring on-chip CAN and Flash. The module is intended for use in memory-intensive applications and in driving a CAN-bus interface. Smaller than a credit card (55 by 47 mm.), the standard board is populated with the ST10F168, the module supports an additional 256 KB of on-chip Flash. PHYTEC FlashTools enable easy on-board download of user code. All controller signals and ports extend to 2x100-pin rows of high-density (0.635) Molex connectors aligning two edges of the board. These pins provide a 16-bit bi-directional I/O port, 64+ free port lines, a 16-channel ADC with 10-bit resolution and two RS-232 interfaces. The ST10F168 supports a single CAN interface. A special feature of the board is the ability to reroute the controller CAN signals from the address lines, enabling direct external addressing of up to 16 MB address space. The phyCORE operates in a standard temperature range from 0 to 70 degrees C. (with extended range from -40 to 85 degrees C.) and requires a low 250 mA. power source.

http://www.phytec.com/products/sbc/C166-xc166-st10-xa/phyCORE-ST10F168.html

Supported Devices

Use the feedback form to tell us about other boards or vendors that should be listed.