Phytec 07. phyCORE-167 System on Module (SOM)

The phyCORE-167/ST10F168 supports high-end 16-bit controllers from Infineon featuring on-chip CAN and Flash. The module is intended for use in memory-intensive applications and in driving a CAN-bus interface. Smaller than a credit card (55 by 47 mm.), the standard board is populated with the Infineon C167CR controller, runs at a 20 MHz clock speed and offers a standard external memory of 256 KB (to 1 MB) SRAM and 256 KB (to 2 MB) Flash. PHYTEC FlashTools enable easy on-board download of user code. All controller signals and ports extend to 2x100-pin rows of high-density (0.635) Molex connectors aligning two edges of the board. These pins provide a 16-bit bi-directional I/O port, 64+ free port lines, a 16-channel ADC with 10-bit resolution and two RS-232 interfaces. If populated with the C167CS, 2 Full 2.0B CAN interfaces are available via two P82C251 CAN transceivers. The C167CR and ST10F168 support a single CAN interface. A special feature of the board is the ability to reroute the controller CAN signals from the address lines, enabling direct external addressing of up to 16 MB address space.

http://www.phytec.com/products/sbc/C166-xc166-st10-xa/phyCORE-167.html

Supported Devices

Use the feedback form to tell us about other boards or vendors that should be listed.