HI! I have actually made a program to initialize a USB port as a host in Keil uVision3. The code i m writing will be implemented on LPC2468ARM7 board. But wen i build da same it shows dis error Error:can't execute 'BIN31\ArmCC' I have searched a lot. Please help ,as i m stuck on dis.
To better understand your issue, I have a few quesitons:
Do you have a C:\Keil\ARM\BIN31\armcc.exe file?
Did you install the Keil tools in the C:\Keil folder?
Which version of the Keil tools are you using?
Can you use a newer version of the tools uv3 is pretty old now.
Hey! - Yes,I have C:\Keil\ARM\BIN31\armcc.exe file but wen i click on the armcc.exe file,it shows PROBLEM :APP CRASH
-Yes I installed all the tools in C:\Keil
-Actually I got this CD with the LPC2468 board,in the kit itself hence installed the uv 3 version. But if that is a problem pls suggest I can install a newer version fr sure.
www.keil.com/.../
I downloaded the uv4 version from MDK421.exe but now when i m debugging ,it shows NO ULINK device found. Pls suggest a solution.
"it shows NO ULINK device found"
Do you have a uLink connected?
Since you updated your tools, the ulink's firmware needs upgrading.
You can try these steps to test windows communication with your ulink
http://www.keil.com/support/man/docs/ulink2/ulink2_su_driver.htm
Double check that the Ulink settings are correct for your device:
http://www.keil.com/support/man/docs/ulink2/ulink2_setup.htm
You may need to run this executable to update the drivers for your ulink:
http://www.keil.com/support/docs/3548.htm
Thankx dt problem is fine. Can u please suggest a simulator for keil uV3 since i need to check nd simulate and am unable to do so.
uVision has its own built-in simulator: http://www.keil.com/support/man/docs/uv3/uv3_db_cpusimulation.htm
The uVision Manual gives you examples of using it: http://www.keil.com/support/man/docs/uv3/uv3_examples.htm
If you downloaded 4.21, you cannot use uVision3 any more - you must use c:\Keil\uv4\uv4.exe
All the ulink dlls are configured for the new IDE.