Peripheral Simulation

For Silicon Laboratories, Inc. C8051F041 — D/A Converter (2x12-bit)

Simulation support for this peripheral or feature is comprised of:

• Dialog boxes which display and allow you to change peripheral configuration.
• VTREGs (Virtual Target Registers) which support I/O with the peripheral.

These simulation capabilities are described below.

Digital / Analog Converter Dialog

The Digital/Analog Converter dialog displays and configures simulation capabilities of the two Digital/Analog Converters. The controls in this dialog are separated into several logical groups.

Digital/Analog Converter 0

• DAC0CN (DAC 0 Control Register) displays and configures the D/A Converter control register.
• DAC0EN (DAC 0 Enable) enables DAC 0 operation.
• DAC0MD (DAC 0 Mode) determines when the DAC output is updated, based on either a write to DAC0 or when Timer 2, 3 or 4 overflows.
• DAC0DF (DAC Data Format) determines the position of the 12-bit digital output within a 16-bit word.

Analog Output 0

• DAC0H (DAC Data Output - High byte) is the MSB of the DAC output word.
• DAC0L (DAC Data Output - Low byte) is the LSB of the DAC output word.
• DAC0 (Output Register) displays the converted analog voltage value.

Digital/Analog Converter 1

• DAC1CN (DAC 1 Control Register) displays and configures the D/A Converter control register.
• DAC1EN (DAC 1 Enable) enables DAC 1 operation.
• DAC1MD (DAC 1 Mode) determines when the DAC output is updated, based on either a write to DAC1 or when Timer 2, 3 or 4 overflows.
• DAC1DF (DAC Data Format) determines the position of the 12-bit digital output within a 16-bit word.

Analog Output 1

• DAC1H (DAC Data Output - High byte) is the MSB of the DAC output word.
• DAC1L (DAC Data Output - Low byte) is the LSB of the DAC output word.
• DAC1 (Output Register) displays the converted analog voltage value.

Reference Voltage

• VREF contains the bandgap output reference voltage.
• VREFD contains the voltage at the DAC voltage reference input pin.
• REF0CN (Reference Control Register) contains the following controls:
• BIASE (Bias Generator Enable) is set to enable internal bias voltage generation.
• REFBE (Reference Buffer Enable) is set to use the VREF pin to drive the internal voltage reference.

DAC1 VTREG
Data Type: float

The DAC1OUT VTREG represents the analog output voltages for simulated D/A converter 1. The DAC1OUT VTREG represents the outputs from the DAC 1 output pin of the MCU.