Keil MCB1000

The Keil MCB1000 Evaluation Board works with the ULINKpro USB-JTAG Adapter. The following instructions show you how to connect and run an example program on this board.

ULINKpro Adapter Connected to MCB1000

To download and run an example project using ULINKpro with the Keil MCB1000 Board:

1. Connect the 10-pin ribbon connector from the ULINKpro Adapter to the Cortex Debug connector on the MCB1000 evaluation board.
2. Connect power to the board using using a USB A to Mini B cable. Connect the other end of this cable to an unused USB port on your PC.
3. Start µVision.
4. Select the BLINKY.UV2 example project from C:\KEIL\ARM\BOARDS\KEIL\MCB1000\BLINKY\.
5. Click the Download button to download the program to the target board.
6. Click the Debug button to start the debugger.
7. Click the Run button to start the program running on the target board.