Keil Logo

Infineon C167 A/D Example Program

This example program shows how to configure and use the A/D Converter of the following microcontrollers:

  • Infineon C167-LM
  • Infineon C167CR-LM
  • Infineon C167CR-L25M
  • Infineon C167CR-16FM
  • Infineon C167CR-16RM
  • Infineon C167CR-4RM
  • Infineon C167CS-LM
  • Infineon C167CS-32FM
  • Infineon C167CS-4RM
  • Infineon C167S-4RM
  • Infineon C167SR-LM

After configuring the A/D, the program reads the A/D result and outputs the converted value using the serial port.

To run this program...

  1. Select the Target device from the pull-down target list
  2. Build the project (Project Menu, Build Target)
  3. Start the debugger (Debug Menu, Start/Stop Debug Session)
  4. View the Serial Window (View Menu, Serial Window #1)
  5. View the A/D converter peripheral (Peripheral Menu, A/D Converter)
  6. Run the program (Debug Menu, Go)
  7. Click on the Toolbox buttons to change input voltages

A debug script (debug.ini) creates buttons that set different analog values in A/D channels. As the program runs, you will see the A/D input and output change.

Other buttons create signals that generate a sine wave or sawtooth patterns as analog inputs. µVision3 users may enable the built-in Logic Analyzer to view, measure and compare these input signals graphically.

C167XX_ADC.ZIP (25K)
Tuesday, July 13, 2004
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.