Texas Instruments MSPM0L1306
ARM Cortex-M0+, 32 MHz, ROM, RAM
The MSPM0L134X and MSPM0L130X microcontrollers (MCUs) are part of MSP's highly-integrated, ultra-low-power 32-bit MCU family based on the enhanced Arm® Cortex®-M0+ core platform operating at up to 32-MHz frequency. These cost-optimized MCUs offer high-performance analog peripheral integration, support extended temperature ranges from -40°C to 125°C, and operate with supply voltages ranging from 1.62V to 3.6V. The MSPM0L134X and MSPM0L130X devices provide up to 64KB embedded Flash program memory with up to 4KB SRAM. They incorporate a high speed on-chip oscillator with an accuracy of ±1%, eliminating the need for an external crystal. Additional features include a 3-channel DMA, 16 and 32-bit CRC accelerator, and a variety of high-performance analog peripherals such as one 12-bit 1MSPS ADC with configurable internal voltage reference, one high-speed comparator with built-in reference DAC, two zero-drift zero-crossover op-amps with programmable gain, one general-purpose amplifier, and an on-chip temperature sensor. These devices also offer intelligent digital peripherals such as four 16-bit general purpose timers, one windowed watchdog timer, and a variety of communication peripherals including two UARTs, one SPI, and two I2C. These communication peripherals offer protocol support for LIN, IrDA, DALI, Manchester, Smart Card, SMBus, and PMBus.
- NVIC:Nested Vectored Interrupt Controller (NVIC) with 32 interrupt sources
- DMA:3 -channel Direct Memory Access (DMA)
- Processor:Cortex-M0+, 32 MHz
- Other Memory:0 x Up to 64KB Flash memory
- Other Memory:0 x Up to 4KB SRAM
- Supply Voltage:1.62 V .. 3.6 V Operating Voltage
- Power Modes:12 Power Modes: RUN0, RUN1, RUN2, SLEEP0, SLEEP1, SLEEP2, STOP0, STOP1, STOP2, STANDBY0, STANDBY1, SHUTDOWN
- Maximum Clock Frequency:32 MHz,
- SPI:1 x SPI interface
- I2C:2 x I2C interface supporting up to FM+ (1Mbps), SMBus/PMBus, and wakeup from STOP mode
- UART:2 x UART inteface, one supporting LIN, IrDA, DALI, Smart Card, Manchester, and three supporting low-power operation in STANDBY mode
- Watchdog:1 x Window-watchdog timer
- Other:4 x 16-bit general purpose timer supporting low power operation in STANDBY mode
- ADC:10-channel x 12 bit ADC
- Other:2 x Zero-drift, zero-crossover chipper op-amp (OPA)
- Other:1 x General-purpose amplifier (GPAMP)
- Other:1 x High-speed comparator (COMP) with 8-bit reference DACs
- Other:1 x Configurable 1.4V or 2.5V internal shared voltage reference (VREF)
- Operating Temperature Range:-40 °C .. 125 °C Extended Operating Temperature Range
- I/Os:28 General purpose I/Os, including some 5-V tolerant
Development Tools | |
CMSIS Drivers | No CMSIS-Driver in Device Family Pack. |