Keil Logo

Peripheral Simulation

For Infineon XE164HM-72F — Timer Block GPT2 (T5, T6)

Simulation support for this peripheral or feature is comprised of:

  • Dialog boxes which display and allow you to change peripheral configuration.

These simulation capabilities are described below.

Timer/Counter 5 Dialog

Timer/Counter 5

The Timer/Counter 5 dialog allows you to view and change the SFRs associated with Timer/Counter 5. This timer/counter is a general purpose unit which may be used for timing, counting, and so on.

  • Mode contains the operating mode and the input selector for the timer.
  • T5UDE is the external up/down control enable.
  • T5EUD is the external up/down control input. This value is obtained from the T5EUD input pin.
  • T5UD is the timer up/down control.
  • Direction displays whether the timer/counter counts up or down.
  • Capture selects the mode of the capture trigger.
  • T5SC enables or disables capture into the CAPREL SFR.
  • CAPIN contains the state of the CAPIN pin of the MCU.
  • CRIR is the Interrupt Request flag for the CAPREL (Capture/Reload) SFR.
  • CAPREL is the value of the Capture/Reload SFR.
  • T5CLR specifies whether or not Timer 5 is cleared on a capture.
  • Status displays the current status of the timer.
  • T5 contains the value of the T5 SFR which is the current timer value or count.
  • T5CON contains the value of the T5CON SFR which is the current configuration for timer 5.
  • T5R is the Timer 5 Run flag.
  • T5IN is the Timer 5 Input value.
  • T5IR is the Timer 5 Interrupt Request flag.

Timer/Counter 6 Dialog

Timer/Counter 6

The Timer/Counter 6 dialog allows you to view and change the SFRs associated with Timer/Counter 6. This timer/counter is a general purpose unit which may be used for timing, counting, and so on.

  • Mode contains the operating mode and the input selector for the timer.
  • T6UDE is the external up/down control enable.
  • T6EUD is the external up/down control input. This value is obtained from the T6EUD input pin.
  • T6UD is the timer up/down control.
  • Direction displays whether the timer/counter counts up or down.
  • T6OTL is the output toggle latch flag.
  • T6OE is the timer output enable flag.
  • T6OUT is the state of the T6OUT output pin.
  • Status displays the current status of the timer.
  • CAPREL is the value of the Capture/Reload SFR.
  • T6 contains the value of the T6 SFR which is the current timer value or count.
  • T6CON contains the value of the T6CON SFR which is the current configuration for timer 6.
  • T6R is the Timer 6 Run flag.
  • T6IN is the Timer 6 Input value.
  • T6SR is the Timer 6 Reload Mode Enable flag.
  • T6IR is the Timer 6 Interrupt Request flag.
  • CRIR is the Interrupt Request flag for the CAPREL (Capture/Reload) SFR.
Get more information about the
Peripheral Simulation Capabilities
of the µVision Debugger.
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.