Keil Logo

Peripheral Simulation

For NXP (founded by Philips) LPC2364 — System Control & Status

Simulation support for this peripheral or feature is comprised of:

  • Dialog boxes which display and allow you to change peripheral configuration.

These simulation capabilities are described below.

System Control & Status Dialog

System Control & Status

The System Control & Status dialog allows you to display and edit the configuration of the System Control & Status flags. The controls in this dialog are as follows:

System Control & Status

  • SCS (SCS Control Register) contains the following control and status settings:
  • GPIOM (GPIO Mode) is set to enable the high-speed GPIO ports 0 and 1.
  • EMC Reset Disable (External Memory Controller Reset Disable) is set to prevent the EMC from resetting during a reset event.
  • MCIPWR Active Level (MCIPWR Pin Control) 0 sets a low-active level, 1 sets a high-active level.
  • OSCRANGE (Main Oscillator Range Select) sets the main oscillator range. 0 sets a reange of 1 MHz to 20 MHz, and 1 sets a range of 15 MHz to 24 MHz.
  • OSCEN (Main Oscillator Enable) is set to enable the main oscillator.
  • OSCSTAT (Main Oscillator Status) is set by the hardware to indicate that the main oscillator is stable and ready for use.
Get more information about the
Peripheral Simulation Capabilities
of the µVision Debugger.
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.