Peripheral Simulation

For NXP (founded by Philips) P89LPC913 — Port 3 (Quasi-bidirectional, Push-Pull, Input Only, Open Drain, 2-bits)

Simulation support for this peripheral or feature is comprised of:

• Dialog boxes which display and allow you to change peripheral configuration.

These simulation capabilities are described below.

Parallel Port 3 Dialog

This dialog displays the SFR and pins of Port 3. This port may be used as a 2-bit general purpose I/O port.

• P3 represents the P3 SFR. The HEX value and value of each bit is displayed and may be changed from this dialog.
• P3M1 and P3M2 configure the output mode of each pin for this port.

• Set P3M1.x:P3M2.x as follows: 0:0 for Quasi-Bidirectional, 0:1 for Push-Pull, 1:0 for Input Only (Hi-Z), or 1:1 for Open Drain.

• Pins represents the states of the pins on the simulated MCU. You may set the level of the input pin to high (1) or low (0).
• ENCLK (Enable Output Clock) is set to output CCLK/2 on the XTAL2 pin (P3.0) and the crystal oscillator is not being used.