For Atmel AT83/87C5112 — X2 Mode for CPU and Each Peripheral with Clock Prescaler and Oscillator A,B,C Control and Configuration
Simulation support for this peripheral or feature is comprised of:
- Dialog boxes which display and allow you to change peripheral configuration.
- VTREGs (Virtual Target Registers) which support I/O with the peripheral.
These simulation capabilities are described below.
Clock Control Dialog
Data Type: unsigned char
The PORTx VTREGs represent the I/O pins of the simulated
MCU for Port 0, Port 1, and so on. PORT0 represents Port 0, PORT1
represents Port 1, etc. You may read PORTx to determine the
state of the output pins of that port. For example, in the command
window, you may type,
to obtain value corresponding to the set pins of Port 0. You may
also change the input values of port pins by changing the value of
the VTREG. For example,
sets the upper four port pins of Port 1 to a value of 1 and the
lower 4 port pins to a value of 0. You may use the bitwise operators
AND(&), OR(|) and XOR(^) to change individual bits of the PORTx
VTREGs. For example:
PORT1 |= 0x01; /* Set P1.0 Pin */
PORT3 &= ~0x02; /* Clr P3.1 Pin */
PORT1 ^= 0x80; /* Toggle P1.7 Pin */
Data Type: unsigned long
The XTAL_x VTREGs (XTAL_A, XTAL_B, XTAL_C) contain the frequency
of the oscillator (in Hertz) used to drive the microcontroller. The
value is automatically set from the value specified in Project
Options - Options for Target. However, you may change the value of
XTAL_x using the command window. For example:
XTAL_x = 12000000
You may also output the current value of XTAL_x using the
XTAL_x may be used in calculations to synchronize external scripts
with the simulated microcontroller.