For Infineon C161K — Port 6 (4-bit I/O with Open Drain)
Simulation support for this peripheral or feature is comprised of:
- Dialog boxes which display and allow you to change peripheral configuration.
- VTREGs (Virtual Target Registers) which support I/O with the peripheral.
These simulation capabilities are described below.
Parallel Port 6 Dialog
This dialog displays the SFR and pins of Port 6. This port may be
used as a 4-bit general purpose I/O port.
P6 represents the P6 SFR. The HEX value and
value of each bit is displayed and may be changed from this
DP6 is the port direction SFR for P6. When
DP6.x=0, P6.x is an input. When DP6.x=1, P6.x is an output.
ODP6 is the open drain control SFR for P6.
When ODP6.x=0, the P6.x output driver works in push/pull mode. When
ODP6.x=1, the P6.x output driver works in open drain mode.
Pins represents the states of the pins on the
simulated MCU. When used as outputs, these have the same value as
the P6 SFR. When used as inputs (DP6.x is 0) you may set the level
of the input pin to high (1) or low (0).
Data Type: unsigned int
The PORTx VTREGs represent the I/O pins of the simulated
MCU for Port 0, Port 1, and so on. You may read PORTx to
determine the state of the output pins of that port. For example, in
the command window, you may type,
to obtain the value corresponding to the set pins of Port 8. You
may also change the input values of port pins by changing the value
of the VTREG. For example,
sets bits 4-7 and clears bits 0-3 and 8-15. You may use the
bitwise operators AND(&), OR(|) and XOR(^) to change individual
bits of the PORTx VTREGs. For example:
PORT2 |= 0x0001; /* Set P2.0 Pin */
PORT8 &= ~0x0002; /* Clr P8.1 Pin */
PORT7 ^= 0x0080; /* Toggle P7.7 Pin */