NXP (founded by Philips) LPC1114LV/103

The NXP (founded by Philips) LPC1114LV/103 is a System - ARM Cortex-M0 processor, running at frequencies of up to 50 MHz. - ARM Cortex-M0 built-in Nested Vectored Interrupt Controller (NVIC). - Serial Wire Debug. - System tick timer. Memory - Up to 32 kB on-chip flash (ISP and IAP via on-chip bootloader software) - Up to 8 kB SRAM. Digital peripherals - Up to 27 General Purpose I/O (GPIO) pins - GPIO pins can be used as edge/level sensitive interrupt sources - High-current output driver (20 mA) on one pin - High-current sink drivers (20 mA) on 2 I2C-bus pins in Fast-mode Plus - 4 general purpose counter/timers - Programmable windowed WDT Analog peripherals - 8-bit ADC with input multiplexing among 6 pins (WLCSP25, HVQFN24 packages) - 10-bit ADC with input multiplexing among 8 pins (HVQFN33 package) Serial interfaces - UART with fractional baud rate generation and internal FIFO - SSP controller with FIFO and multi-protocol capabilities - I2C-bus interface Clock generation - 12 MHz internal RC Oscillator (IRC) - Crystal Oscillator (SysOsc) with operating range of 1 MHz to 25 MHz - Programmable watchdog oscillator with a frequency range of 9.4 kHz to 2.3 MHz - PLL allows CPU operation up to the maximum CPU rate - Clock output function with divider that can reflect various clocks Power control - 2 reduced power modes: Sleep and Deep-sleep - Ultra-low power consumption in Deep-sleep mode (< 1.6 uA) - 5 us wake-up time from Deep-sleep mode - Processor wake-up from Deep-sleep mode via a dedicated start logic using up to 13 of the functional pins. - Power-On Reset (POR) - Brown-Out Detection (BOD) Unique device serial number for identification.