Keil Logo

NXP (founded by Philips) LPC11U37/401

The NXP (founded by Philips) LPC11U37/401 is an ARM Cortex-M0 processor: - running at frequencies of up to 50 MHz - Nested Vectored Interrupt Controller (NVIC) - Non Maskable Interrupt (NMI) - System tick timer Memory: - Up to 128 kB on-chip Flash (ISP and IAP via on-chip bootloader software) - Up to 12 kB SRAM - 4 kB on-chip EEPROM - 16 kB boot ROM ROM based drivers: - Power profiles - 32-bit integer division routines - USB drivers Debug options: - Standard JTAG test/debug interface - Serial Wire Debug (SWD) Digital peripherals: - Up to 54 General Purpose I/O (GPIO) pins - Up to 8 GPIO pins can be used as edge/level sensitive interrupt sources - Two GPIO grouped interrupt modules - High-current source output driver (20 mA) on 1 pin - High-current sink driver (20 mA) on true open-drain pins - 4 general purpose counter/timers - Programmable windowed WatchDog Timer (WDT) Analog peripherals: - 10-bit ADC with input multiplexing among 8 pins Serial interfaces: - USB 2.0 FS device controller - UART with internal FIFO, and RS-485 support USART supports an asynchronous smart card interface (ISO 7816-3) - 2 SSP controllers - I2C-bus interface Clock generation: - Crystal Osc. with operating range of 1 MHz to 25 MHz - 12 MHz Internal high-frequency RC osc. (IRC) - Internal low-power, low-frequency WatchDog Osc. (WDO) - PLL allows CPU operation up to the maximum CPU rate - 2nd dedicated PLL for USB - Clock output function with divider that can reflect clocks Power control: - Integrated PMU (Power Management Unit) - 4 reduced power modes (Sleep, Deep-sleep, Power-down, Deep power-down) - Processor wake-up from Deep-sleep, Power-down modes - Processor wake-up from Deep power-down mode using 1 special function pin - Integrated PMU (Power Management Unit) - Power-On Reset (POR) - Brown-Out Detect (BOD) Unique device serial number for identification Single 3.3 V power supply (1.8 V to 3.6 V).

[Distributors]

Development Tools
Compiler, Assembler, Linker, Debugger
JTAG Debuggers
Data Sheets
Data Sheet
1,850,537 bytes
Generic User Guide
953,546 bytes
Technical Reference Manual
472,236 bytes
User Manual
3,640,613 bytes

Get Adobe Acrobat Reader

Header Files
FLASH Utilities
Device Programmers
Real-Time OS
Simulated Features
NOTE
Simulation for this device is provided by the default peripheral simulation driver.

Complete peripheral simulation is not available and is not planned to be implemented by ARM.

  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.