Keil Logo

Spansion MB9BF515N

The Spansion MB9BF515N is a 32-bit ARM Cortex-M3 Core (r2p1) - Up to 144MHz Frequency Operation - Memory Protection Unit (MPU) - Integrated Nested Vectored Interrupt Controller (NVIC) - 24-bit System timer (Sys Tick) On-chip Memories - Up to 512 Kbyte MainFlash - 32 Kbyte WorkFlash - Up to 32 Kbyte SRAM for high-performance CPU - Up to 32 Kbyte SRAM for CPU/DMA Controller External Bus Interface - Supports SRAM, NOR& NAND Flash device - Up to 8 chip selects - 8/16-bit Data width - Up to 25-bit Address bit USB Interface (Device / Host) - USB2.0 Full/Low speed supported - Max. 6 EndPoint supported CAN Interface (Max. 2chn) - Compatible with CAN Specification 2.0A/B - Maximum transfer rate: 1 Mbps Multi-function Serial Interface (Max 8chn) - UART, CSIO, LIN, I2C DMA Controller (8chn) A/D Converter (Max 16chn) - 12-bit A/D Converter Base Timer (Max 8chn) - Operation mode: 16-bit PWM, 16-bit PPG, 16/32-bit reload, 16/32-bit PWC General Purpose I/O Port - Up 103 fast I/O Ports Multi-function Timer (Max 3units) Real-time clock (RTC) Quadrature Position/Revolution Counter (QPRC) (Max 3chn) Dual Timer (32/16bit Down Counter) Watch Counter External Interrupt Controller Unit - Up to 32 external vectors - Include non-maskable interrupt (NMI) Watchdog Timer (2channels) CRC (Cyclic Redundancy Check) Accelerator Clock and Reset - 5 clock sources (2 ext. osc, 2 CR osc, and PLL) - Reset sources: INITX Pins, POR, SW, Watchdog, LVD, CSV Clock Super Visor (CSV) - Ext. OSC clock failure (clock stop) detect - Ext. OSC frequency anomaly detect Low Voltage Detector (LVD) - LVD1: error reporting via interrupt - LVD2: auto-reset operation Low Power Mode - Three power saving modes (SLEEP, TIMER, STOP) Debug - Serial Wire JTAG Debug Port (SWJ-DP) - Embedded Trace Macrocells (ETM).

[Chip Vendor] [Distributors]

Development Tools
Compiler, Assembler, Linker, Debugger
JTAG Debuggers
Data Sheets
Data Sheet
1,276,618 bytes
Generic User Guide
1,364,135 bytes
Technical Reference Manual
1,106,603 bytes

Get Adobe Acrobat Reader

Header Files
FLASH Utilities
Real-Time OS
Simulated Features
NOTE
Simulation for this device is provided by the default peripheral simulation driver.

Complete peripheral simulation is not available and is not planned to be implemented by ARM.

  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.