Keil Logo

Atmel SAM3S8B

The Atmel SAM3S8B is a Core: - ARM Cortex-M3 (r2p0) running at up to 64 MHz - Memory Protection Unit (MPU) Pin-to-pin compatible with AT91SAM7S legacy products (64-pin versions), SAM3S4/2/1 products Memories: - 512 Kbytes Embedded Flash (Single Plane, 128-bit wide access, memory accelerator) - 64 Kbytes Embedded SRAM - 16 Kbytes ROM with embedded boot loader routines (UART, USB) and IAP routines - 8-bit Static Memory Controller (SMC): SRAM, PSRAM, NOR and NAND Flash support System: - Embedded voltage regulator for single supply operation - Power-on-Reset (POR), Brown-out Detector (BOD), Watchdog (WTD) - Quartz or ceramic resonator oscillators: 3 to 20 MHz main power - RTC with Gregorian and Persian Calendar mode - RTC clock calibration circuitry for 32.768 kHz crystal frequency compensation - High precision 8/12 MHz internal RC oscillator (4 MHz default frequency) - Slow Clock Internal RC oscillator as permanent low-power mode device clock - 2 PLLs up to 130 MHz for device clock and for USB - Temperature Sensor - Up to 24 peripheral DMA (PDC) channels Low Power Modes: - Sleep and Backup modes - Ultra low-power RTC Peripherals - USB 2.0 Device (up to 8 bidirectional EPs) - Up to 3 USARTs (ISO7816, IrDA, RS-485, SPI, Manchester and Modem Mode) - 2 2-wire UARTs - Up to 2 Two Wire Interface (I2C compatible), 1 SPI, 1 Serial Synchronous Controller (I2S), 1 High Speed Multimedia Card Interface (SDIO/SD Card/MMC) - 6 3-chn 16-bit Timer/Counter with capture, waveform, compare and PWM mode - 4-chn 16-bit PWM with Complementary Output, Fault Input, 12-bit Dead Time Generator Counter for Motor Control - 32-bit Real-time Timer and RTC - Up to 15-chb, 1Msps ADC - 1 2-chn 12-bit 1Msps DAC - 1 Analog Comparator (flexible input selection) - 32-bit Cyclic Redundancy Check Calculation Unit (CRCCU) I/O - Up to 79 I/O lines with external interrupt capability - 3 32-bit Parallel I/O Controllers.

[Chip Vendor] [Distributors]

Development Tools
Compiler, Assembler, Linker, Debugger
JTAG Debuggers
Data Sheets
Datasheet
20,160,483 bytes
Generic User Guide
1,364,135 bytes
Technical Reference Manual
2,467,498 bytes

Get Adobe Acrobat Reader

Header Files
FLASH Utilities
Real-Time OS
Simulated Features
NOTE
Simulation for this device is provided by the default peripheral simulation driver.

Complete peripheral simulation is not available and is not planned to be implemented by ARM.

  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.