NXP (founded by Philips) LPC1776

The NXP (founded by Philips) LPC1776 is an ARM Cortex-M3 processor: - running at frequencies of up to 100 MHz. - Memory Protection Unit (MPU). - Nested Vectored Interrupt Controller (NVIC). - Non-maskable Interrupt (NMI) input. - Wakeup Interrupt Controller (WIC). - Up to 512 kB on-chip Flash (ISP and IAP capabilities). - Up to 96 kB on-chip SRAM - Up to 4 kB on-chip EEPROM. - External Memory Controller (EMC). - DMA controller (GPDMA). - JTAG interface, Serial Wire Debug, and Serial Wire Trace Port options. - Four reduced power modes: Sleep, Deep-sleep, Power-down, Deep power-down. Clocks: - On-chip crystal oscillator (operating range of 1 MHz to 25 MHz). - 12 MHz Internal RC oscillator (IRC). - On-chip PLL allows CPU operation up to the maximum CPU rate. - Second, dedicated PLL may be used for the USB interface. - Clock output function that can reflect various clocks. LCD controller: - supporting STN and TFT displays. - Selectable display resolution (up to 1024 × 768 pixels). - Supports up to 24-bit true-color mode. Serial interfaces: - Ethernet MAC with MII/RMII interface. - USB 2.0 full-speed controller configurable for either device, Host, or OTG. - Five UARTs with IrDA, and RS-485/EIA-485 support. - Three SSP controllers. - Three enhanced I2C-bus interfaces. - Two-channel CAN controller. - Inter-IC Sound (I2S) interface for digital audio input or output. Other peripherals: - SD card interface that also supports MMC cards. - up to 165 General Purpose I/O (GPIO) pins. - 12-bit Analog-to-Digital Converter (ADC). - 10-bit Digital-to-Analog Converter (DAC). - Four general purpose timers/counters. - One motor control PWM with support for three-phase motor control. - Quadrature encoder interface. - Two standard PWM/timer blocks. - Real-Time Clock (RTC). - Event Recorder. - Windowed Watchdog Timer (WWDT). - Cortex-M3 system tick timer. - CRC Engine block. Functional replacement for LPC23xx, LPC24xx.