Support forums

Keil forum ERRORLEVEL from command-line invocation of uVision2

State Not Answered
Locked Locked
Replies 2 replies
Subscribers 15 subscribers
Views 1668 views
Users 0 members are here

Options

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ERRORLEVEL from command-line invocation of uVision2

Kevin Priest over 19 years ago

I am integrating our builds into the Ant and CruiseControl architecture, but have run into a problem: when invoking uVision2 from the command line, e.g.:

uv2 -b washer.uv2

uVision2 never sets ERRORLEVEL (to a nonzero value), even when the build fails. Short of going around uVision2 directly to the compiler and linker, is there a way to get uVision2 to set ERRORLEVEL on failure?

0 Walt Conley over 19 years ago

I tried it with uv3 and it also seems to return only zero. The manual says that the compiler and assember set ERRORLEVEL so I'm guessing you would have to call these programs directly from your batch file instead of calling uv2.exe with the build command.

http://www.keil.com/support/docs/613.htm
Cancel
Up 0 Down

Cancel
0 Andy Neil over 19 years ago in reply to Walt Conley

"I'm guessing you would have to call these programs directly"

Yes, I think that is the case - whether you use a simple batch file, or a makefile, or something else.
Cancel
Up 0 Down

Cancel