Keil Logo

Spansion MB9AF154R

The Spansion MB9AF154R is a 32-bit ARM Cortex-M3 Core (r2p1) - Up to 40 MHz Frequency Operation - Integrated Nested Vectored Interrupt Controller (NVIC) - 24-bit System timer (Sys Tick) On-chip Memories - Up to 512 Kbytes Main Flash - 32 Kbytes Work Flash - SRAM0: Up to 32 Kbytes (connected to I-code bus or D-code bus) - SRAM1: Up to 32 Kbytes (connected to System bus) External Bus Interface - Supports SRAM, NOR NAND Flash memory device - Up to 8 chip selects - 8/16-bit Data width - Up to 25-bit Address bit Multi-function Serial Interface (Max 16chn) - UART, CSIO, I2C DMA Controller (8chn) A/D Converter (Max 24chn) - 12-bit A/D Converter Base Timer (Max 16chn) -Operation mode: 16-bit PWM, 16-bit PPG, 16/32-bit reload, 6/32-bit PWC General-Purpose I/O Port - Up to 103 high-speed general-purpose I/O Dual Timer (32/16-bit Down Counter) Multi-function Timer Quadrature Position/Revolution Counter (QPRC) HDMI-CEC/Remote Control Reception (Up to 2chn) Real-time clock (RTC) Watch Counter External Interrupt Controller Unit - Up to 24 external interrupt input pins - Include non-maskable interrupt (NMI) input pin Watchdog Timer (2chn) CRC (Cyclic Redundancy Check) Accelerator Clock and Reset - 5 clock sources (2 ext. osc, 2 CR osc, and PLL) - 6 Reset sources (INITX pin, POR, SW, Watchdog, LVD, CSV) Clock Super Visor (CSV) Low-Voltage Detector (LVD) - LVD1: error reporting via interrupt - LVD2: auto-reset operation Low-Power Consumption Mode - 6 low-power consumption modes SLEEP, TIMER, RTC, STOP, Deep standby RTC, Deep standby STOP Debug - Serial Wire JTAG Debug Port (SWJ-DP) - Embedded Trace Macrocells (ETM): MB9AF154M, F155M, F156M only SWJ-DP Unique ID - Unique value of the device (41 bits).

[Chip Vendor] [Distributors]

Development Tools
Compiler, Assembler, Linker, Debugger
JTAG Debuggers
Data Sheets
Data Sheet
1,542,612 bytes
Generic User Guide
1,364,135 bytes
Technical Reference Manual
1,106,603 bytes

Get Adobe Acrobat Reader

Header Files
FLASH Utilities
Real-Time OS
Simulated Features
NOTE
Simulation for this device is provided by the default peripheral simulation driver.

Complete peripheral simulation is not available and is not planned to be implemented by ARM.

  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.