Keil Logo

NXP (founded by Philips) LPC11A14/301

The NXP (founded by Philips) LPC11A14/301 is an ARM Cortex-M0 processor: - running at frequencies of up to 50 MHz - Nested Vectored Interrupt Controller (NVIC) - Serial Wire Debug - System tick timer Memory: - Up to 32 kB on-chip Flash (ISP and IAP via on-chip bootloader software) - Up to 4 kB on-chip EEPROM - Up to 8 kB SRAM - 16 kB boot ROM Digital peripherals: - Up to 42 General Purpose I/O (GPIO) pins - Up to 16 pins are configurable with a digital input glitch filter - GPIO pins can be used as edge/level sensitive interrupt sources - High-current source output driver (20 mA) on one pin - High-current sink driver (20 mA) on true open-drain pins - 4 general purpose counter/timers - Programmable windowed WatchDog Timer (WDT) Analog peripherals: - 10-bit ADC with input multiplexing among 8 pins - 10-bit DAC with flexible conversion triggering - Highly flexible analog comparator with a programmable voltage reference - Integrated temperature sensor - Internal voltage reference - UnderVoltage Lockout (UVLO) protection Serial interfaces: - UART with internal FIFO, and RS-485 support - 2 SSP controllers with FIFO and multi-protocol capabilities - I2C-bus interface Clock generation: - Crystal Oscillator (SysOsc) with operating range of 1 MHz to 25 MHz - 12 MHz internal RC Oscillator (IRC) - Internal low-power, Low-Frequency Oscillator (LFOsc) with programmable frequency output - Clock input for external system clock (25 MHz typical) - PLL allows CPU operation up to the maximum CPU rate - Clock output function with divider that can reflect various clocks Power control: - Reduced Power Mode: Sleep mode. - Power profiles residing in boot ROM allowing to optimize performance and minimize power consumption - Processor wake-up from reduced power mode using any interrupt - Power-On Reset (POR). - Brown-Out Detect (BOD) Unique device serial number for identification Single 3.3 V power supply (1.8V to 3.6V).

[Distributors]

Development Tools
Compiler, Assembler, Linker, Debugger
JTAG Debuggers
Data Sheets
Data Sheet
1,779,191 bytes
Generic User Guide
953,546 bytes
Technical Reference Manual
472,236 bytes
User Manual
2,425,253 bytes

Get Adobe Acrobat Reader

Header Files
FLASH Utilities
Real-Time OS
Simulated Features
NOTE
Simulation for this device is provided by the default peripheral simulation driver.

Complete peripheral simulation is not available and is not planned to be implemented by ARM.

  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.