Keil Logo

Atmel SAM3S2C

The Atmel SAM3S2C is a Core - ARM Cortex-M3 revision 2.0 running at up to 64 MHz - Memory Protection Unit (MPU) - Thumb-2 instruction set Pin-to-pin compatible with AT91SAM7S series (48- and 64-pin versions) Memories - 64 to 256 Kbytes Flash, 128-bit wide access, memory accelerator, single plane - 16 to 48 Kbytes SRAM - 16 Kbytes ROM with embedded bootloader routines (UART, USB) and IAP routines - 8-bit Static Memory Controller (SMC): SRAM, PSRAM, NOR and NAND Flash support System - Embedded voltage regulator for single supply operation - Power-on-Reset (POR), Brown-out Detector (BOD) and Watchdog - Quartz or ceramic resonator oscillators: 3 to 20 MHz main power with Failure Detection - High precision 8/12 MHz factory trimmed internal RC oscillator with 4 MHz default frequency - Slow Clock Internal RC oscillator as permanent low-power mode device clock - Two PLLs up to 130 MHz for device clock and for USB - Temperature Sensor - Up to 22 peripheral DMA (PDC) chns Low Power Modes - Sleep and Backup modes - Ultra low power RTC Peripherals - USB 2.0 Device: 12 Mbps, 2668 byte FIFO, up to 8 bidirectional Endpoints - Up to 2 USARTs with ISO7816, IrDA, RS-485, SPI, Manchester and Modem Mode - Two 2-wire UARTs - Up to 2 Two Wire Interface (I2C compatible), 1 SPI, 1 Serial Synchronous Controller (I2S), 1 High Speed Multimedia Card Interface (SDIO/SD Card/MMC) - Up to 6 Three-chn 16-bit Timer/Counter - 4-chn 16-bit PWM with Complementary Output, Fault Input, 12-bit Dead Time Generator Counter for Motor Control - 32-bit Real-time Timer and RTC with calendar and alarm features - Up to 15-chn, 1Msps ADC - One 2-chn 12-bit 1Msps DAC - One Analog Comparator - 32-bit Cyclic Redundancy Check Calculation Unit (CRCCU) - Write Protected Registers I/O - Up to 79 I/O lines with external interrupt capability - Three 32-bit Parallel Input/Output Controllers.

[Chip Vendor] [Distributors]

Development Tools
Compiler, Assembler, Linker, Debugger
Evaluation Boards
JTAG Debuggers
Data Sheets
Datasheet
7,812,274 bytes
Generic User Guide
1,364,135 bytes
Technical Reference Manual
2,467,498 bytes

Get Adobe Acrobat Reader

Header Files
Example Code
FLASH Utilities
Device Programmers
MDK Middleware
The following middleware components are pre-configured in MDK-Professional
Real-Time OS
Simulated Features
NOTE
Simulation for this device is provided by the default peripheral simulation driver.

Complete peripheral simulation is not available and is not planned to be implemented by ARM.

  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.