Keil Logo

Infineon XC164CS-16R

The Infineon XC164CS-16R is a Microcontroller Built Around the Synthezisable C166S V2 Core with 2K Bytes Dual-port RAM for Register Sets and System Stack, 2K Bytes Data RAM Controlled by DMU, Internal Instruction Memory Block (IMB) Controlled by PMU, Program Memory Interface (PMI), 128K Bytes ROM, 2K Bytes RAM, 8K Bytes Start-up ROM, Intelligent On-chip Peripheral Subsystems, Automotive-specific Peripherals (ADC and TwinCAN), Debug and Emulation Control Blocks.

[Chip Vendor] [Distributors]

Development Tools
Compiler, Assembler, Linker, Debugger
Evaluation Boards
JTAG Debuggers
Data Sheets
Data Sheet for the Infineon XC164CS-16R
Data Sheet
1,133,328 bytes
Instruction Set Manual for the Infineon XC164CS-16R
Instruction Set Manual
5,532,154 bytes
Peripheral Units User's Manual for the Infineon XC164CS-16R
Peripheral Units User's Manual
3,667,342 bytes
System Units User's Manual for the Infineon XC164CS-16R
System Units User's Manual
3,598,564 bytes

Get Adobe Acrobat Reader

Application Notes
Header Files
FLASH Utilities
Device Programmers
Real-Time OS
Simulated Features

The following on-chip peripherals are simulated by the Keil Software µVision Debugger.

  • A/D Converter (14 channels)
  • Asynchronous/Synchronous Serial Interface ASC0
  • Asynchronous/Synchronous Serial Interface ASC1 (without Autobaud)
  • Capture/Compare Unit CAPCOM1 with T0 and T1 (without pins)
  • Capture/Compare Unit CAPCOM2 with T7 and T8 (12 I/O Pins only)
  • Capture/Compare unit CAPCOM6 with T12, T13
  • CPU Configuration
  • High-Speed Synchronous Serial Interface SSC0
  • High-Speed Synchronous Serial Interface SSC1
  • Interrupts
  • NMI
  • PEC
  • Port 0 (2 x 8-bit I/O)
  • Port 1 (2 x 8-bit I/O)
  • Port 20 (5-bit I/O)
  • Port 3 (14-bit I/O with Open Drain)
  • Port 4 (8-bit I/O with Open Drain)
  • Port 5 (14-bit Input with Disable)
  • Port 9 (6-bit I/O with Open Drain)
  • Real Time Clock
  • Reset Configuration
  • System Control Unit
  • Timer Block GPT1 (T2, T3, T4)
  • Timer Block GPT2 (T5, T6)
  • Traps
  • TwinCAN Module
  • Watchdog Timer

The following on-chip peripherals are not simulated.

  • External Bus Controller
  • Flash Program Memory
  • Power Management (Peripheral Disabling)
  • Programmable Frequency Output Signal
  • Register Security Mechanism
  • Sleep and Power-Down Mode
AGDI Drivers

The following AGDI Drivers are available for the Keil Software µVision Debugger.


  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.