 | Device Database® |  |
|
|
Product Information Device Database® Downloads Compliance Testing Distributors | Texas Instruments MSC1201Y3The Texas Instruments MSC1201Y3 is an 8051-compatible Microcontroller with 16 I/O Lines, 6 Channel 24-bit A/D Converter, 20 Interrupt Sources, Two 16-bit Timer/Counters, Watchdog Timer, UART, Basic SPI, Basic I2C, Power Management, Digital Brownout Reset, Low Voltage Detection, 32-bit Accumulator, 8K Bytes Flash, 256 Bytes DATA, 1K Byte BOOT ROM available in 6mm X 6mm QFN.
Development Tools
Compiler, Assembler, Linker, Debugger |
Data Sheets 
|
| Simulated Features The following on-chip peripherals are simulated by the Keil Software µVision Debugger. - 32-bit Accumulator
- 4 clocks per Machine Cycle
- A/D Converter (without calibration)
- Hardware Configuration
- Interrupts 20S/2L (including extended external interrupts and Auxilliary Interrupts)
- Port 1 (standard 8051, push-pull outputs, open drain outputs, inputs only)
- Port 3 (standard 8051, push-pull outputs, open drain outputs, inputs only)
- Power save modes (Idle & Power down)
- Serial UART 0 (standard interface)
- System Timer
- Timer 0
- Timer 1
- Timer Rate Control & External Memory Strech Cycle support
- Watchdog Timer
The following on-chip peripherals are not simulated. - Basic I²C Interface
- Basic SPI
- Boot ROM
- D/A Converter (8-bit Current)
- Flash Memory
- PLL Clock
|
AGSI Drivers The following AGSI Drivers are available for the Keil Software µVision Simulator. |
AGDI Drivers The following AGDI Drivers are available for the Keil Software µVision Debugger. |
|
|
|
