|
Product Information Device Database® Evaluation Software Compliance Testing Distributors | NXP (founded by Philips) LPC2138The NXP (founded by Philips) LPC2138 is an ARM7TDMI-S based high-performance 32-bit RISC Microcontroller with Thumb extensions 512KB on-chip Flash ROM with In-System Programming (ISP) and In-Application Programming (IAP), Two 8-ch 10bit ADC 32KB RAM, Vectored Interrupt Controller, Two UARTs, one with full modem interface. Two I2C serial interfaces, Two SPI serial interfaces Three 32-bit timers, Watchdog Timer, Real Time Clock with optional battery backup, Brown out detect circuit General purpose I/O pins. CPU clock up to 60 MHz, On-chip crystal oscillator and On-chip PLL.
Data Sheets 
|
| Development Tools
Compiler, Assembler, Linker, Debugger |
Simulated Features The following on-chip peripherals are simulated by the Keil Software µVision Debugger. - A/D Converter 0 (8 Channels)
- A/D Converter 1 (8 Channels)
- A/D Global Start
- D/A Converter
- External Interrupts
- General Purpose Input/Output (GPIO): Port0: 30-Bit
- General Purpose Input/Output (GPIO): Port1: 16-Bit
- I²C Interface: I2C0
- I²C Interface: I2C1
- IAP Flash Memory Programming
- Memory Accelerator Module (MAM)
- Memory Mapping Control
- Phase Locked Loop (PLL)
- Pin Connect Block
- Power Control
- Real Time Clock
- SPI Interface: SPI0
- SSP Interface
- Timer 0
- Timer 1
- UART0
- UART1
- Vectored Interrupt Controller (VIC)
- VPB Divider
- Watchdog
The following on-chip peripherals are not simulated. |
AGDI Drivers The following AGDI Drivers are available for the Keil Software µVision Debugger. |
Consultants The following consultants have experience with this device. |
|
|
|
