|
||
| Products Download Events Support Videos | ||
Technical Support
On-Line Manuals
ULINKpro User's Guide
Introduction
Hardware Description
Setup ULINKpro
Using ULINKpro
Configure Cortex-M Devices for Tracing
Cortex-M0+/M23 MTB Devices
Enable MTB Trace
NXP MKL25Z Devices
Enable Micro Trace Buffer (MTB)
NXP MK70FN1M Devices
Enable 4-Pin Trace (ETM)
Enable Embedded Trace Buffer (ETB)
Enable Serial Wire Trace
NXP LPC17xx Devices
Enable 4-Pin Trace (ETM)
Enable Serial Wire Trace
NXP LPC43xx Devices
Enable 4-Pin Trace (ETM)
Enable Embedded Trace Buffer (ETB)
Enable Serial Wire Trace
STMicroelectronics STM32F10xxx Devices
Enable 4-Pin Trace (ETM)
Enable Serial Wire Trace
STMicroelectronics STM32F2xx Devices
Enable 4-Pin Trace (ETM)
Enable Serial Wire Trace
STMicroelectronics STM32F3xx Devices
Enable 4-Pin Trace (ETM)
Enable Serial Wire Trace
STMicroelectronics STM32F4xx Devices
Enable 4-Pin Trace (ETM)
Enable Serial Wire Trace
TI LM3Sx Devices
Enable Serial Wire Trace
Microchip AT91SAM3 Devices
Enable Serial Wire Trace
Toshiba TMPM330 Devices
Enable 4-Pin Trace (ETM)
Enable Serial Wire Trace
µVision Windows
Troubleshooting
Appendix
NXP MK70FN1M Devices
NXP MK70FN1M devices support the CoreSight features including ETB trace. No additional target resources are needed for debugging. By default, MK70FN1M devices debug in JTAG mode and can be switched to Serial Wire Debug mode.
To use the CoreSight trace functionalities, the device, the debugger adapter, as well as µVision have to get configured:
ProductsDevelopment Tools |
Hardware & Collateral |
Downloads |
Support |
Contact |
 |
||||