|
||
| Products Download Events Support Videos | ||
Technical Support
On-Line Manuals
ULINKpro User's Guide
Introduction
Hardware Description
Setup ULINKpro
Using ULINKpro
Configure Cortex-M Devices for Tracing
Cortex-M0+/M23 MTB Devices
Enable MTB Trace
NXP MKL25Z Devices
Enable Micro Trace Buffer (MTB)
NXP MK70FN1M Devices
Enable 4-Pin Trace (ETM)
Enable Embedded Trace Buffer (ETB)
Enable Serial Wire Trace
NXP LPC17xx Devices
Enable 4-Pin Trace (ETM)
Enable Serial Wire Trace
NXP LPC43xx Devices
Enable 4-Pin Trace (ETM)
Enable Embedded Trace Buffer (ETB)
Enable Serial Wire Trace
STMicroelectronics STM32F10xxx Devices
Enable 4-Pin Trace (ETM)
Enable Serial Wire Trace
STMicroelectronics STM32F2xx Devices
Enable 4-Pin Trace (ETM)
Enable Serial Wire Trace
STMicroelectronics STM32F3xx Devices
Enable 4-Pin Trace (ETM)
Enable Serial Wire Trace
STMicroelectronics STM32F4xx Devices
Enable 4-Pin Trace (ETM)
Enable Serial Wire Trace
TI LM3Sx Devices
Enable Serial Wire Trace
Microchip AT91SAM3 Devices
Enable Serial Wire Trace
Toshiba TMPM330 Devices
Enable 4-Pin Trace (ETM)
Enable Serial Wire Trace
µVision Windows
Troubleshooting
Appendix
Microchip AT91SAM3 Devices
Microchip AT91SAM3 devices support all standard CoreSight features. ETM trace is not included. No additional target resources are needed for debugging. By default, AT91SAM3 devices debug in JTAG mode, and can be switched to Serial Wire mode. AT91SAM3 devices offer ITM and DWT trace data.
To use the CoreSight trace functionalities, the debugger adapter and connector, as well as µVision have to be configured properly:
For additional information, refer to the AT91 ARM Cortex-M3 based Microcontrollers - SAM3U Series manual.
ProductsDevelopment Tools |
Hardware & Collateral |
Downloads |
Support |
Contact |
 |
||||