Keil Logo

Configuring the MCBTMS570

The MCBTMS570 Development Kit is configured using 4 jumpers and 3 DIP switches located on the MCBTMS570 IO Board. The MCBTMS570 IO Board ships with the following configuration:

Jumpers

Jumper State Description
P7
ON Grounds the nWAKE signal on the TPIC1021 (IC35) LIN transceiver.
LIN_MASTER
ON Supplies 12 VDC to the VSUP pin on the TPIC1021 (IC35) LIN transceiver.
SE1
ON Grounds the IN- signal to the Sensor 1 instrumentation amplifier.
SE2
ON Grounds the IN- signal to the Sensor 2 instrumentation amplifier.

DIP Switches

Switch State Description
LIN/485
485 Switches the LIN/RS485 SCI1 signals to the RS485 transceiver.
SW4
OFF Disables the watch dog timer.
SW5
OFF Removes power from the pressure sensor.
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.