Keil Logo

Checking Program Output

To check the program output from the BLINKY program, start the program running either from the debugger via JTAG or by cycling power on the board. The LEDs will flash in sequence.  Changing the potentiometer setting increases or decreases the speed of the LED flashing sequence.

Pressing the PJ4, PJ5, PJ6 or PJ7 buttons on the MCBTMPM360 board turns on LED PM4, PM5, PM6 or PM7, respectively. The LED flashing sequence continues if these buttons are pressed.

  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.