Keil Logo

Debugging VOICE

Debug the VOICE example program following this procedure. The debugged program is ready for the serial output check.

Debug ButtonUse the Start/Stop Debug Session toolbar button or the µVision command Debug - Start/Stop Debug Session to connect the debugger to the Keil ULINK Adapter. The CPU stops and connects to the Embedded ICE of the LPC214x device. For details on the debugging features, refer to the µVision User's Guide.

Note

  • Debugging the VOICE program using the µVision debugger requires a ULINK USB-JTAG adapter.  

When you start a debug session, the following occurs:

  1. The FLASH.INI file executes and loads the Audio.H86 file to on-chip Flash.
  2. The VOICE.ELF program file downloads to Flash, and the Flash load is verified.
  3. The VOICE.ELF program loads in the debugger.
  4. The debugger sets the program counter to 0 and displays the source code at that location.

You may now set breakpoints in your program code and run the VOICE program under debugger control.

Note

  • When restarting a debug session, be sure to disconnect the USB power cable for at least 10 seconds to allow the board to power down properly.
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.