|
||
| Products Download Events Support Videos | ||
Technical Support
On-Line Manuals
MCB1200 User's Guide
Introduction
Setup
Theory of Operation
Block Diagram
Schematics
Technical Data
Prototyping Access
Microcontroller
Power Supply
Cortex Debug Interface
LEDs
Push Buttons
Serial Port
Writing Programs
Example Programs
Serial Port
The MCB1200 board connects the on-chip serial UART to the ST3232 (IC6) which converts the logic signals to RS-232 voltage levels.
In addition to the standard 3-wire interface, the COM DB9 connector is wired to allow a board RESET via the DTR pin, and to enable In-System Programming (ISP) via the RTS pin as shown in the figure below.
ProductsDevelopment Tools |
Hardware & Collateral |
Downloads |
Support |
Contact |
 |
||||