Keil Logo

MON166: Problems with The Infineon EASY UTAH Board


Information in this article applies to:

  • C166
  • Infineon EASY UTAH Board

QUESTION

I have the Infineon EASY UTAH Board for the C161U or C165UTAH and I'm trying to use the Keil Monitor-166 together with the µVision Debugger for serial debugging through the ASC0 port. So far, I can't get the monitor to work. What is wrong?

ANSWER

The Infineon EASY UTAH Board has additional non-standard lines on the UART connector. You need a modified Monitor DLL that sets the correct levels on this UART connector.

You must copy the modified DLL to the Keil\C166\Monitor folder.

As an alternative you may consider OCDS Debugging using Keil ULINK.


ATTACHED FILES

Request the files attached to this knowledgebase article.

Last Reviewed: Thursday, February 25, 2021


Did this article provide the answer you needed?
 
Yes
No
Not Sure
 
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.