This program is a SNMP_Agent example. It shows how to use a Simple 
Network Management Protocol to control the embedded system.

Use this example to connect an evaluation board to a LAN with DHCP
server (most LANs have this). This example will configure the network
parameters automatically using a DHCP protocol.

If a DHCP server is not available, you may connect an evaluation
board to PC directly over a crosslink network cable. In this case
configure a PC to use a static IP address 192.168.0.1 and disable
a 'Dynamic Host Configuration' in Net_Config_ETH_#.h configuration file.
The default static IP address of this example is then 192.168.0.100

To test this example, run windows application 'SNMPTest.exe' on your PC.
Enter the IP address of your embedded SNMP_Agent and click on 'Connect'.
When connected, you can change the LCD text on the target, control the
onboard LED diodes and monitor the state of onboard pushbuttons.

The SNMP_Agent program is a standalone application preconfigured for
NXP MIMXRT1060-EVKC Evaluation Board.

The program is available in different targets:
 - Debug:
   - Code:                      External QSPI Flash NOR
   - RW:                        Internal RAM
   - Debugger:                  CMSIS-DAP
   - Compiler:                  ARM Compiler optimization Level 1
   - Compiler:Event Recorder:   Enabled
   - CMSIS:RTOS2:Keil RTX5:     Source
   - Network:CORE:              IPv4/IPv6 Debug
 - Release:
   - Code:                      External QSPI Flash NOR
   - RW:                        Internal RAM
   - Debugger:                  CMSIS-DAP
   - Compiler:                  ARM Compiler optimization Level 3
   - Compiler:Event Recorder:   Disabled
   - CMSIS:RTOS2:Keil RTX5:     Library
   - Network:CORE:              IPv4/IPv6 Release

Notes:
 - In case of debugging problems consult the documentation and Blinky example
 - Power the board with external power through J45 barrel connector with 
   stable 5V voltage (center +), jumper J40 short 1-2, switch SW6 position 2-3
 - Define ETH_PHY_REF_CLK_50M=1 must be set to build KSZ8081RNA
   Ethernet PHY driver with support for 50MHz reference clock.
 - LCD output is re-targeted to debug console (virtual COM port) accessible on the
   same J53 connector as CMSIS-DAP debugger.
