This program is a BSD_Server example. It is used to serve LED control
requests received from the client.

In order to run this example, you need to set the network parameters
to match your local area network.

To test this example, run windows application "LEDSwitch.exe" on your PC.
Enter the IP address, server port and select the transfer protocol TCP or UDP.
When you change the value of P2 in windows application, LED diodes on
evaluation board should light accordingly.

The same example can be tested also with BSD_Client running on another
evaluation board. 

The BSD_Server program is a standalone application preconfigured for
NXP MIMXRT1060-EVKC Evaluation Board.

The program is available in different targets:
 - Debug:
   - Code:                      External QSPI Flash NOR
   - RW:                        Internal RAM
   - Debugger:                  CMSIS-DAP
   - Compiler:                  ARM Compiler optimization Level 1
   - Compiler:Event Recorder:   Enabled
   - CMSIS:RTOS2:Keil RTX5:     Source
   - Network:CORE:              IPv4/IPv6 Debug
 - Release:
   - Code:                      External QSPI Flash NOR
   - RW:                        Internal RAM
   - Debugger:                  CMSIS-DAP
   - Compiler:                  ARM Compiler optimization Level 3
   - Compiler:Event Recorder:   Disabled
   - CMSIS:RTOS2:Keil RTX5:     Library
   - Network:CORE:              IPv4/IPv6 Release

Notes:
 - In case of debugging problems consult the documentation and Blinky example
 - Power the board with external power through J45 barrel connector with 
   stable 5V voltage (center +), jumper J40 short 1-2, switch SW6 position 2-3
 - Define ETH_PHY_REF_CLK_50M=1 must be set to build KSZ8081RNA
   Ethernet PHY driver with support for 50MHz reference clock.
 - LCD output is re-targeted to debug console (virtual COM port) accessible on the
   same J53 connector as CMSIS-DAP debugger.
