Keil Logo

Connecting ULINKpro

To connect ULINKpro with the target hardware and PC, plug the:

  1. 20-pin or 10-pin cable into the target connector.
  2. USB cable into the PC and into the ULINKpro's USB connector.

ULINKpro connected

Note

  • The red stripe on the cable marks pin 1.
  • If necessary (especially with STM32 development boards), use the ULINK SWD adapter supplied with the kit.
  • Use the 20-pin Cortex Debug+ETM connector when ETM tracing is required.
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.