Keil Logo

Enable Serial Wire Trace

To enable Serial Wire Trace on Luminary LM3Sx devices:

  • Connect ULINKpro to the board's Cortex Debug connector and to the host computer.
  • Configure µVision to capture Serial Wire Trace data.

Configure µVision to capture Serial Wire Trace data

  1. Open the dialog Options for Target — Debug.

    Select ULINKpro as the debugger adapter

  2. Enable Use, select ULINK Pro Cortex Debugger, and click Settings to open the Target Driver Setup dialog.

    Configure the Serial Wire Debug mode

  3. Enable SWJ and select SW.
  4. Click the Trace tab.

    Configure Luminary devices for Serial Wire Trace

  5. Set Trace Enable.
  6. Set the Trace Port to Serial Wire Output - Manchester and enable Autodetect.
  7. The Core Clock must correspond to the device configuration.

Start the debugging session and verify the captured trace data with a µVision window.

Note

  • Use the examples delivered with the Luminary board ek-lm3s6965 as a reference.
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.