Keil Logo

SW Device

The SW Device section displays one or more debug targets connected through the Serial Wire interface. The IDCODE and Device Name are displayed automatically for each device.

Target Driver Setup - SW Device

  • AP specifies the identifier of the Access Port in multi-core devices with a single Debug Port.
    • The AP value range is 0 to 255.
    • For single core devices, set AP to 0 (default).
    • For a multi-core device, core 0 is expected to have AP=0 and core 1 AP=1. However, the port identifiers are specified by the device manufacturer.

    If AP contains an invalid identifier, the error message "Invalid ROM Table" is shown whenever a debuging session is started.

Note

  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.