Keil Logo

Debug Driver

Debug configurations define the way ULINKpro is debugging and connecting to the target hardware.

  1. Options for Target Open the dialog Options for Target — Debug. Enable Use and select ULINK Pro Cortex Debugger.

    Select Target Driver

    • Enable Load Application at Startup to load the object file into the µVision Debugger.
    • Enable Run to main() to execute code until main() is reached.
  2. Click Settings to configure the debug and connect behavior.
    1. Click on the Pack tab if available, and check Enable. Refer to Pack Options for details.
    2. When the Pack tab if missing, then you may use an Initialization File to execute special commands or functions that prepare the device for debugging or tracing.
  3. Click the Debug tab to set the configuration.

    Options for Target - Debug - Use ULINK Selection

    The Target Driver Setup dialog consists of three configuration groups:

  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.