Keil Logo


The ULINKplus window shows the status of the ULINKplus' I/O pins and the power measurement values. Open it using View - Analysis Windows - ULINKplus.

ULINKplus Window

The I/O section shows how the I/O pins are configured:

  • Pin - Displays the pin number
  • Function - Displays the current function set that is applied to the I/O. You can change the function set by clicking on the current function:
    Function change
  • Out - If the function is "Digital Output", you can set the output to high by checking the box. Otherwise the output is low. For Pin 7, when configured for Analog Output, the pin voltage displays. You can change the voltage by entering a new value.
  • In - Displays the current I/O voltage level if configured to "Digital Input"

The Power section shows these values:

  • Shunt R - Displays and sets the external shunt resistance in Ohms. Change the shunt value by entering the new value here.
  • Voltage - Displays the measured voltage
  • Current - Displays the measured current
  • Power - Displays the calculated power
  • Enable - Is checked or unchecked to allow or prevent power measurement capture (required for System Analyzer).


The ULINKplus window is only available if you are using a ULINKplus debug adapter.

  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.