Keil Logo

Technical Characteristics

The following table is an overview of the technical characteristics. Refer to Hardware description for further details on the specific ULINKplus interfaces.

Interface Description
USB USB 2.0 high-speed
Provides power supply for ULINKplus
JTAG/SWD Voltage range: 1.2 V .. 5.5 V
Clock speed: configurable up to 10 MHz
SWO trace capturing: data rate up to 50 Mbit/s (UART/NRZ Mode)
Isolation: 1 kV
Supports hot-plugging to a running target
Power Sample rate: 20 MSPS (16-bit delta-sigma technology)
Input bandwidth (BW): 1 MHz
Configurable digital low-pass filters: 160, 80, 40, 20, 10 and 5 kHz
Input voltage range: +/- 6.0 V
  - Precision: +/- 2%
  - Resolution: 0.6mV
Input current range (with internal shunt resistor): +/- 2.5mA
  - Precision: +/- 2%
  - Resolution: 200nA
  Current range is extended using external shunt resistors
Isolation: 1 kV
I/O 9 configurable I/O pins support:
  - Up to 9 digital I/O pins
  - Up to 4 analog input pins (3 if analog output is required)
  - 1 analog output pin (reconfigures 1 analog input pin)
Additional +3.3 V supply voltage (10mA) switchable

  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.