Keil Logo Arm Logo

Debugging Programs

Follow the steps to debug applications using the µVision Debugger and ULINK2.

  1. Connect ULINK2 to the PC and to the target board.
  2. Power up the target board.
  3. Configure the Debugger.
  4. Start the Debugger.

    Start/Stop Debug ButtonUse the button Start/Stop Debug Session to start debugging the application.

    If the flag Update Target before Debugging is set, then the debugger loads the application to target prior to starting a debugging session.

Note

  • Details about debugging features are explained in the µVision User's Guide chapter Debugging, and Getting Started User's Guide chapter Start Debugging.

Keil logo

Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings