| ||||
| Home Products Download Events Support | ||||
Technical Support
On-Line Manuals
ULINK2 User's Guide
Introduction Hardware Description 
Setup ULINK2 
Connecting ULINK2 Installing Drivers Configure µVision for Debugging ARM Devices Debug Driver Configuration ULINK USB-JTAG Adapter JTAG Device Chain Debug Cortex-M Debugging Debug Driver Configuration ULINK USB-JTAG/SW Adapter JTAG/SW Device Debug Trace Configuration Trace Port Timestamps PC Sampling Trace Events ITM Stimulus Ports Setup Flash Programming Using ULINK2 Configure Cortex-M Devices for Tracing µVision Windows Real-Time Agent Evaluation Boards AppendixConnecting ULINK2
Connecting ULINK2 to the target system is easy.
- Simply plug the ULINK2 JTAG-cable into the JTAG or Cortex Debug connector of the board. The red cable-stripe marks pin 1 of the JTAG-connector.
- Then, plug a USB cable into the PC and ULINK2.
ULINK2 Adapter Connected to Target Hardware
ULINK2 connects to the target board via a ribbon cable attached to one of five JTAG interfaces:
- ARM 10-pin interface (1.27mm/0.05" pin spacing).
- ST 14-pin interface.
- OCDS 16-pin interface.
- ARM 20-pin interface (2.0mm/0.079" pin spacing).
- ARM 20-pin interface (2.54mm/0.1" pin spacing).
ULINK2 Adapter Target Connections
The Target Connectors page provides the JTAG signal and pin assignment information.
| Contact Site Map Press Privacy | Copyright © 2012 ARM Ltd and ARM Germany GmbH. All rights reserved. |
