| ||||
| Home Products Download Events Support | ||||
Technical Support
On-Line Manuals
ULINK2 User's Guide
Introduction Hardware Description 
Setup ULINK2 
Connecting ULINK2 Installing Drivers Configure µVision for Debugging ARM Devices Debug Driver Configuration ULINK USB-JTAG Adapter JTAG Device Chain Debug Cortex-M Debugging Debug Driver Configuration ULINK USB-JTAG/SW Adapter JTAG/SW Device Debug Trace Configuration Trace Port Timestamps PC Sampling Trace Events ITM Stimulus Ports Setup Flash Programming Using ULINK2 Configure Cortex-M Devices for Tracing µVision Windows Real-Time Agent Evaluation Boards AppendixULINK USB-JTAG/SW Adapter
The section ULINK2 USB-JTAG/SWD Adapter displays driver, device, and firmware information about ULINK2.
Serial No displays the serial number of the ULINK2 adapter. When more ULINK2 adapters are connected, use the drop-down list to select the adapter that should be used.
SWJ enables ULINK2 to switch between JTAG and Serial Wire (SW) mode automatically. Enable SWJ on devices with a combined Serial Wire/JTAG interface. Disable SWJ on devices that only have the Serial Wire interface mode.
Port sets the debugging interface: JTAG or SW. With SW, ULINK2 uses only two pins for communication, as described in CoreSight Technology.
Max Clock sets the clock rate used to communicate to the target board.
| Contact Site Map Press Privacy | Copyright © 2012 ARM Ltd and ARM Germany GmbH. All rights reserved. |
