| ||||
| Home Products Download Events Support | ||||
Technical Support
On-Line Manuals
ULINK2 User's Guide
Introduction Hardware Description Setup ULINK2 Setup Flash Programming Using ULINK2 
Configure Cortex-M Devices for Tracing Atmel AT91SAM3 Devices 
Enable Serial Wire Trace Luminary LM3Sx Devices Enable Serial Wire Trace NXP LPC17xx Devices Enable Serial Wire Trace STMicroelectronics STM32F10xxx Devices Enable Serial Wire Trace Toshiba TMPM330 Devices Enable Serial Wire Trace µVision Windows Real-Time Agent AppendixEnable Serial Wire Trace
To enable Serial Wire Trace on Atmel AT91SAM3 devices:
- Use a ULINK2 connector interface that supports Serial Wire, and connect ULINK2 to the board and to the host computer.
- Configure µVision to capture Serial Wire Trace data.
Configure µVision to capture Serial Wire Trace data
- Open the dialog Options for Target — Debug.
- Enable Use, select ULINK Cortex Debugger, and click Settings to open the Target Driver Setup dialog.
- Enable SWJ and select SW.
- Click the Trace tab.
- Set Trace Enable and Autodetect.
- The Core Clock must correspond to the device configuration.
Start the debugging session and verify the captured trace data with a µVision window.
| Contact Site Map Press Privacy | Copyright © 2012 ARM Ltd and ARM Germany GmbH. All rights reserved. |
