Keil Logo

Toshiba TMPM330 Devices

Toshiba TMPM330 devices support all CoreSight features including ETM trace. No additional target resources are needed for debugging. By default, TMPM330 devices debug in JTAG mode and can be switched to Serial Wire Debug mode. TMPM330 devices offer ETM, ITM, and DWT trace data. However, to capture ETM trace data, a ULINKpro debugger adapter is needed instead of ULINK2.

To use the CoreSight trace functionalities, the TMPM330 device, the debugger adapter and connector, as well as µVision have to be configured properly:

Note

  • Debug and trace operations are prohibited when the device's Security Function is enabled.
  • The watchdog timer stops in debug mode.
  • When PA0 and PB0 are configured as debug pins, output is enabled even in STOP mode, regardless of the SYSCR2<DRVE> or STBYCR2<DRVE> bit setting.
  • When PA1 is configured as a debug pin, low-power mode is not fully effective. Configure PA1 as a general-purpose port, if the debug function is not used.
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.